Curved Bench | Retaining Wall Paver Manufacturers | Western Interlock
Stone Pavers and Retaining Wall Blocks Western Interlock Logo

Paving Stones and Retaining Wall Systems Made for the Northwest.

Curved Bench

Western Interlock pavers are made from natural materials and due to variables in the photographic reproduction process, the actual color of the stones may vary slightly. For a truly accurate representation, we invite you to stop by any of our retail facilities to see them in person.

Architect Information
Are you an architect, and looking for more detailed product info? Check out our full documents list.

Other Information:

Project Time: 4-6 hours

Project materials included:
30 pieces Tegula Wall
35 pieces (+ 4 “1/2 cut” piece) Tegula Beveled Pieces
8 pieces Rotundo med,12 pieces Rotundo rec, &
6 pieces Rotundo large
2 pieces Flat Caps (20” x 20”)
2 tubes Glue

Tools Needed:
String line, level, gloves, shovel, wheel barrow, tape measure, caulking gun & Rubber mallet

Gluing Method:
4 quarter size blobs in each corner about 1 inch away from any edges

Installation Instructions:

Step 1 – Prepare the site
Set stake at center of main focus & run a 6’3” string and mark with paint the outside circumference for a distance of 9’ 11”. Dig 16” wide from mark and down 8”. Fill with 3/4 – gravel and tamp solid.

Step 2 – Lay corner pillar
If using Rotundo Circle System, Bench will set on circle row 8 & 9. Starting at the edge lay 4 Tegula Walls to create the pillar. Continue laying stones from edge of Pillar.

Step 3 – Lay Bottom course
Lay 8 Tegula Beveled pieces following front arc of the area. For back arc of the bench lay 10 Tegula Beveled pieces & then 1 “1/2 cut” Tegula Beveled piece against the end pillar.

Step 4 – Continue laying
For the second course of the back arc of the bench, lay the “1/2 cut” Tegula Beveled piece next to opposite pillar of the first course. Then lay 10 Tegula Beveled pieces.

Step 5 – Set & Glue
In front starting with 2 “1/2 cut” Tegula Beveled pieces lay one next to each opposite pillars , then lay 7 Tegula Beveled Pieces. Bench is 2 courses high with Rotundo pieces for caps..

Step 6 – Cap the wall
Pillars are 4 stone high and then a 24” x 24” Flat cap is added. Bench front arc uses 7 Rotundo med & 6 Rotundo Rec. Bench back arc uses 1 Rotundo med, 6 Rotundo Rec & 6 Rotundo large.

* Click on images to enlarge.